Images are for illustration purposes only. Actual product may vary, make sure to verify the specifications and datasheets.

BlueSolar PWM LCD-USB 48V-30A

Liquid crystal display

For status monitoring and set-up

Load output

Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect the load when the battery has been discharged to a pre-set voltage.

Some loads (especially inverters) can best be connected directly to the battery, and the inverter remote control connected to the load output. A special interface cable may be needed, please see the manual.

The connect and disconnect voltages are adjustable.

Day/night timing of the load output

This option allows for a pre-set ON-time after dusk.

Programmable battery charge algorithm

Preprogrammed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (with internal BMS only)

Two 5 Volt USB outputs

Maximum current (both outputs combined): 2A

SCC040030050

Data sheet

Battery Voltage
48V
Charge Current
30A

Download

DS-PWM-1224V-48V-LCDUSB.pdf

Datasheet BlueSolar PWM Charge Controller-LCD&USB 12/24V & 48V

Download (224.95k)